Replacing The Fuses; Maintaining The Headlights - Toro Workman GTX Operator's Manual

Replacing the Fuses

There is 1 fuse in the electrical system; the other slots
are open for options. They are located under the seat
assembly behind a battery on the right side of the
machine (Figure 43).
Optional lift kit—open
Main power
Horn—optional (standard on
International models only)
Figure 43
1. Fuse block

Maintaining the Headlights

Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the
15 A
system is designed for, you may damage the
10 A
12 V power supply, or at a minimum, blow the
30 A
fuse.
Always use the specified Toro LED bulb to
prevent this issue.
CAUTION
The bulbs become extremely hot when in
operation. Handling a hot bulb can cause
severe burns and personal injury.
Always allow enough time for the bulbs
to cool before replacing them. Use care
whenever handling the bulb.
Specification: See your Parts Catalog.
1. Disconnect the batteries; refer to
the Batteries (page
2. Open the hood; refer to
30).
g036964
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly at the back of the headlight housing
(Figure 44).
1. Headlight housing
2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn
counterclockwise and moving it rearward,
out of the headlight housing
5. Insert the new lamp assembly and headlight
housing and align the tabs in the lamp assembly
40
Disconnecting
39).
Raising the Hood (page
Figure 44
3. Harness-electrical
connector
(Figure 44).
g035852