Front Fan Assembly - Lenovo ThinkStation P720 Hardware Maintenance Manual

d. Insert the corresponding end of the holder into the gaps in the PCIe card latch as shown. Pivot the
holder downward to insert the part
pivot the tab on the front fan assembly to secure the holder.
Figure 131. Installing the super capacitor module
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 220.

Front fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
CAUTION:
Keep fingers and other parts of your body away from hazardous, moving parts. If you suffer an injury,
seek medical care immediately.
To remove or install the front fan assembly, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 103.
2. Remove the following devices if any:
• M.2 solid-state drive holder, see "M.2 solid-state drive" on page 146
• Any full-length PCIe cards, see "Full-length PCIe card" on page 164
• PCIe card retainer, see "PCIe card" on page 158
• Super capacitor module, see "Super capacitor module" on page 167
3. To remove the front fan assembly, do the following:
a
into the corresponding slot in the front fan assembly. Then,
Chapter 9
.
Hardware removal and installation
169