d. Tighten the screw to secure the new M.2 solid-state drive.
Note: Do not overtighten the screw.
Figure 103. Securing the M.2 solid-state drive
8. To install the M.2 solid-state drive heat sink, do the following:
a. If necessary, remove the film that protects the thermal pad on the heat sink.
b. Insert the two hooks on the heat sink into the corresponding holes in the M.2 solid-state drive holder
as shown
1
. Then, press the heat sink downward. Ensure that the mounting stud on the heat sink is
aligned with the hole in the M.2 solid-state drive holder
Figure 104. Installing the heat sink onto the M.2 solid-state drive holder
150
P720 Hardware Maintenance Manual
2
.