About This Manual - ABB COM600 3.4 User Manual

1MRS755382
1.
1.1.
1.2.
1.3.
Station Automation COM600 3.4
IEC 60870-5-101 Slave (OPC) User's Manual

About this manual

Copyrights
The information in this document is subject to change without notice and should not be
construed as a commitment by ABB Oy. ABB Oy assumes no responsibility for any
errors that may appear in this document.
In no event shall ABB Oy be liable for direct, indirect, special, incidental, or consequential
damages of any nature or kind arising from the use of this document, nor shall ABB Oy
be liable for incidental or consequential damages arising from use of any software or
hardware described in this document.
This document and parts thereof must not be reproduced or copied without written per-
mission from ABB Oy, and the contents thereof must not be imparted to a third party
nor used for any unauthorized purpose.
The software or hardware described in this document is furnished under a license and
may be used, copied, or disclosed only in accordance with the terms of such license.
Copyright 2006 ABB. All rights reserved.
Trademarks
ABB is a registered trademark of ABB Group. All other brand or product names men-
tioned in this document may be trademarks or registered trademarks of their respective
holders.
General
This manual provides thorough information on the OPC Client for IEC 60870-5-101
Slave protocol (later referred to as IEC101 Slave OPC Client) and the central concepts
related to it. You find instructions on to take it into use. The basic operation procedures
are also discussed.
Information in this user's manual is intended for application engineers who configure
IEC101 Slave OPC Client to establish communication to an OPC server.
As a prerequisite, you should understand IEC870-5-101 protocol and the basic procedures
in Station Automation Builder 600 (later referred to as SAB600).
This user's manual is divided into following sections:
7