Fujitsu ETERNUS CS800 S6 User Manual page 258

1. Under Target System, click the box next to Throttling.
The Replication Throttle window displays (see
Figure 179: Replication Throttle
2. Select the Enable system throttling check box, or clear the check box to disable system
throttling.
3. In the Throttle box, enter the maximum allowed bandwidth, and select the units you
want to use to specify the constant throttle
(KB/s or MB/s). The lowest value you can set is 32 KB/s. The lowest value you can set is
32 KB/s. The highest value you can set is 125 MB/s for 1GbE and 500 MB/s for 10GbE.
4. Click Apply.
CAUTION!
Do not set the maximum allowed bandwidth to a value that is lower than necessary.
If the maximum allowed bandwidth is set to the lowest value, large replication jobs
may fail.
Source ETERNUS CS800 List
The Source System list displays the following information for each source ETERNUS CS800:
Source
Actual Data Received
Average Receive Rate
You can customize the appearance of the Source System list in the following ways:
Click the top banner row of the list to collapse or expand the list.
l
Click the arrow to the right of a column heading and select Sort Ascending or Sort
l
Descending to sort the rows in the table by that column.
ETERNUS CS800
"Replication Throttle" on page
The IP address of the source system that is allowed to
send data to the ETERNUS CS800.
The amount of data actually received over the network
during replication or failback.
The average receive rate (in MB/s) of data received over
the network during replication or failback (Actual Data
Received divided by the amount of time required to
complete replication or failback).
10.5 Replication Configuration
258).
258