LampSite
Installation Guide
6.4.2 pRRU3901 Installed on a Wall
If the wall indoors has sufficient load bearing capacity and space, the pRRU3901 is
recommended to install on a wall. If the wall cannot bear the capacity, choose an installation
mode based on site requirements.
Context
This section only describes the procedure of installing the pRRU3901 on a wall without any
other auxiliary devices. The installation procedure of other wall-mounted modes is similar to
that of installing the pRRU3901 on a wall without auxiliary devices.
Procedure
Step 1 Determine the position for installing the pRRU3901 based on the construction blueprint and the
space requirements.
Step 2 Place the plate in the installation position against the wall. Then, level the plate and mark the
two anchor points using a marker, as shown in
Figure 6-7 Anchor points of the pRRU3901 installation kits (unit: mm)
(1) Wall
Issue 08 (2015-01-15)
NOTICE
NOTE
For pRRU3901 installation space requirements, see Space Requirements.
(2) Plate
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
6-7.
(3) Anchor point
6 Installing a pRRU3901
60