Philips IntelliVue TRx Instructions For Use Manual page 70

Battery Information
Removing the To remove the batteries, open the battery compartment door and push from the
Batteries opening at the back of the compartment to pop the batteries out. Transceiver
settings (ECG leadset type, SpO
when the batteries are removed.
If you remove good batteries to turn off the transceiver, keep them together as a
set for later re-use so that both batteries will have the same level of power
remaining.
Batteries should be removed when the transceiver is not in use or is being stored.
Important—
INCORRECT POLARITY POSITION IN THE TRANSCEIVER.
Be careful not to short circuit the batteries. Batteries can get hot when shorted.
Short circuits are caused when a piece of metal touches both the positive and
negative terminals simultaneously. More than a momentary short circuit will
generally reduce the battery life. In case of a short circuit, discard both batteries
in a pair, or just the shorted one if the batteries are new.
Disposal of When disposing of batteries, follow local laws for proper disposal. Dispose of
Batteries batteries in approved containers. If local regulations require you to recycle
batteries, recycle batteries in accordance with those regulations.
4-16 Basic Operation
Draft - 1 Aug 08
mode, volume, etc.) are retained indefinitely
2
DO NOT "STORE" BATTERIES BY LEAVING THEM IN THE