Unpairing The Monitor And Transceiver - Philips IntelliVue TRx Instructions For Use Manual

To pair the transceiver to the monitor:
When connected, the
The transceiver is assigned to the monitor. A "Tele Device Assigned" message
appears on the monitor, a tone sounds at the transceiver and its Leads Off
indicators light to indicate the successful assignment. If the ECG wave now
appears on the monitor, the signal from the transceiver is successfully
transmitting to the monitor. To confirm that the correct transceiver has been
assigned, open the ECG Setup menu by touching the ECG waveform or HR
numeric. The title of the menu contains the equipment label of the transceiver.
Check that this is the correct label.
If a monitor is already paired to another device, you cannot assign a transceiver
to that monitor.
If the transceiver goes out-of-range or loses the short-range radio connection, it
will switch over to standard telemetry transmission to the Information Center. In
this case, the telemetry data is displayed in the Telemetry Data Window.
If the devices are unpaired, the short-range radio connection is ended.
Unpairing
If the patient will no longer be monitored with the transceiver, or only with the
the Monitor
transceiver and no longer with the monitor, you need to end the device pairing.
and
After unpairing, the Information Center will receive data exclusively from the
Transceiver
monitor or from the transceiver:
Draft - 1 Aug 08
1. Press the Check Button on the transceiver. The measurement selection key
on the monitor will change to show the "assign telemetry" icon
2. Select the assing telemetry icon.
3. In the Assign Telemetry Device menu, select the correct equipment label
for the device.
• select the Unpair To Mon.
the Information Center receive the measurement data from the monitor
• select the Unpair To Tele
the Information Center receive the measurement data from the transceiver
or
• use the Unpair function at the Information Center.
icon appears at the Information Center.
SmartKey to end pairing and have
SmartKey to end pairing and have
Pairing Monitoring Devices
Pairing Networked Devices
.
10-7