OfficeServ 7200 Installation Manual/Ed.00
3
Mounting Interface Module
This section describes how to set jumpers and switches of an interface Module,
how to mount optional Modules to an interface Module, and how to mount
interface Modules into slots.
3.1
Setting Switches and Mounting Optional Modules
Interface Modules that are equipped with switches/jumpers used for accommodating
user requirements or system configuration, and those with connectors for optional
Modules are as follows:
Interface
Module
WIM
MGI
TEPRI
4BRI
MGI
Interface Module
WIM
MGI
© SAMSUNG Electronics Co., Ltd.
Table 3.5 Interface Modules with Jumpers/Switches
Jumpers/Switches
JP1~JP4
Memory backup switch
JP3-JP9
SW1~SW8
S2
Table 3.6 Interface Modules Accommodating Optional Modules
WIMD(Default)
MGI2D
CHAPTER 3. Mounting and Replacing Modules
Description
Sets whether to use the Ethernet port of the front panel
or the back panel when connecting to the LIM Module.
Sets memory backup
Sets E1, T1/E1/PRI, 24B+D/24B, USER/NETWORK and
17H/13H
Sets termination resistors on or off
Sets memory backup
Optional Module
Page 3-9