Connecting Mcp Module To Lcp Module; Figure 3.7 Extension Cables; Figure 3.8 Connecting Mcp Module To Lcp Module - Samsung OfficeServ 7200 Installation Manual

CHAPTER 3. Mounting and Replacing Modules
2.3

Connecting MCP Module to LCP Module

If the OfficeServ 7200 system consists of a basic Chassis and an extension Chassis,
connect the MCP Module to the LCP Module using extension cables to transmit
and receive signals between the control Modules.
1) Three extension cables are needed to connect the MCP Module to the LCP
Module, these are provided with the LCP Module and MUST NOT be substituted.
2) One of the three extension cables is for connecting the LINK1 port of the MCP
Module of the basic Chassis to the LINK1 port of the LCP Module of the
expansion Chassis.
Another cable is for connecting the LINK2 port of the MCP Module to LINK2 port
of the LCP Module. The last one is for connecting the LINK3 port of the MCP
Module to LINK3 port of the LCP Module.
Page 3-8

Figure 3.7 Extension Cables

LINK1
LINK3
LINK2

Figure 3.8 Connecting MCP Module to LCP Module

OfficeServ 7200 Installation guide/Ed.00
© SAMSUNG Electronics Co., Ltd.