Hitachi Compute Blade 500 Series User Manual page 45

Item
Displaying safe
mode status
Releasing safe mode Resources tab > Modules > All Modules > Server Blades >
Item
Displaying safe mode status
Releasing safe mode
Table 1-28 HVM management command (HvmSh)
Item
Displaying safe mode status get ConfigAll → HVM_CONFIGURATION record in the
Releasing safe mode
Downgrading the firmware
To restore the version of LPAR manager, management module, and server
blade firmware to a previous version, reset "Specify management NIC" of the
management path setting to "Disable" in advance, and then connect the
management path to 1a / 1b.
N+M cold standby
The versions of LPAR manager firmware, management module firmware, and
the server blade firmware on the standby server blade must be equal to or
later than those on the active server blade. If one or more firmware versions
are earlier than those indicated in the "Firmware combinations" table, the
standby server uses not the specified ports but the default ports (1a/1b) as
the management path after failover, so LPAR manager fails to start or starts
in an unexpected state.
For details on the firmware combinations, see
page 1-28.
Cloning
The cloning function of JP1/SC/BSM does not inherit the setting of ports used
as the management path. At the cloning target, manually set the ports before
booting LPAR manager.
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table 1-26 Web Console
Resources tab > Modules > All Modules > Server Blades >
Server Blades x > LPAR Manager tab
Server Blades x > LPAR Manager tab > Exit safe mode
Table 1-27 LP screen
LP Options → System Control → Safe Mode
LP Options → System Control → Safe Mode
indication result
set HvmOptions
LPAR manager Functions
Operation
Operation
Operation
Firmware combinations on
1-31