Hitachi Compute Blade 500 Series User Manual page 270

Item
Host key
Generate
Host Key
User
Information
Legend:
Y: can be changed
-: cannot be changed
How to set the LP ID
Place the cursor on the LP ID and press [Enter] to display a sub-screen. Enter
the new ID on the sub-screen. LP ID is used to identify of each when the
multiple LPAR manager systems exist. For example, when you control the
LPAR manager system from ServerConductor/Blade Server Manager (BSM),
LP ID is used to identify each. Therefore, when setting the LP ID, set a value
that is unique among all LPAR manager systems including Compute Blade
Series.
LPAR manager does not check if the entered value is used for another LPAR
manager system. You can change the LP ID only when all LPARs are
deactivated.
How to set the ServerConductor/Blade Server Manager (BSM) IP
Address
Place the cursor on the BSM IP Address and press [Enter] to display a sub-
screen. Enter the new System Manager IP Address on the sub-screen and
press [Enter].
Note:
• Operation with [F10]: Update System Config is not required to reflect a
setting change. It may take about 10 seconds to reflect a setting change.
How to set the ServerConductor/Blade Server Manager (BSM) Alert
Port
Place the cursor on the BSM Alert Port and press [Enter] to display a sub-
screen. Enter the new BSM Alert Port Number in the sub-screen and press
[Enter].
7-66
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
LPAR Status
Activate Deactivate
- -
Y Y
- -
Operation by LPAR manager Screen
Remark
Failure
- displayed
only
Y -
- displayed
only
Supported
LPAR
manager
Version
02-05~
02-05~
02-05~