Hitachi Compute Blade 500 Series User Manual page 288

• Save the configuration using [F9]: Save Configuration on the Menu
screen.
How to adjust the RTC time of LPARs to the LPAR manager system
time
The RTC time of LPARs can be set only when the relevant LPAR is
deactivated.
Case1: When synchronizes LPAR manager system time by an NTP server
(recommended)
See How to use NTP on LPAR manager on page 7-88
Perform the procedure as below, when NTP setting has already been done.
• Place the cursor on [Adjust LPAR Time] in the [Date and Time] screen,
and press [Enter] to display a sub-screen. Select the target LPAR and
press [Enter].
• This operation makes the RTC time of LPAR (logical RTC time) adjusted to
LPAR manager system time.
• Save the configuration using [F9]: Save Configuration on the Menu
screen.
Case2: When do not synchronize the LPAR manager system time by a NTP
server
• Shutdown All the guest Oss
• Shutdown the LPAR manager
• Synchronizes the system time
• Boot the LPAR manager and connect to the LPAR manager screen
• Place the cursor on [LPAR RTC] on the Date and Time screen and press
[Enter] to display a sub-screen. Select [LPAR SEL Time] and press
[Enter].
7-84
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Figure 7-34 Date and Time Screen
Figure 7-35 LPAR manager Menu Screen
Operation by LPAR manager Screen
for setting NTP.