Checking After The Installation; Powering On The Rp - Huawei RP100 Installation Manual

14 Checking After the Installation

For the items to be checked after installation, see "Room Presence Hardware and Cable
Connections" in the RP100&RP200 V500R002C00 Acceptance Test Guide.
To obtain this guide, visit http:www.huawei.com and search for RP100&RP200 V500R002C00
Acceptance Test Guide.

15 Powering On the RP

Press the power button, which is located in the
1
lower right corner of the rack, to turn it ON.
After the RP has started, observe
2
TE30/VPC600 and HD display status.
Model Name Status
The status indicator blinks green for several seconds. The LCD displays
TE30 a message indicating that the system is starting. After the system has
started, the camera rotates for several seconds and then stops rotating.
RP-S
The status indicator is steady red and the display says that the system is
HD
being started up. After a few seconds, the indicator is off. A boot
display
animation plays.
The status indicator blinks green for several seconds. The LCD displays
VPC60
a message indicating that the system is starting. After the system has
0
started, the camera rotates for several seconds and then stops rotating.
RP-A
The status indicator is steady red and the display says that the system is
HD
being started up. After a few seconds, the indicator is off. A boot
display
animation plays.
42
Power
button
Troubleshooting
Power off the RP
and check cable
connections by
referring to "Room
Presence
Hardware and
Cable
Connections" in the
RP100&RP200
V500R002C00
Acceptance Test
Guide.