Huawei RP100 Installation Manual page 41

12 Installing the TE30/VPC600
4
Install the crimping cover.
6
Install the rear cable cover.
Insert the crimping cover into the
bottle gourd–shaped mounting pegs.
Tighten the captive screws.
Insert the dowel into its hole.
38
Insert the TE30 cables
5
into the rack and pull
them out from the middle
part of the upper front
panel.
The yellow cable
is indicative.
DANGER
When mounting the rear
access panel onto the rack,
watch your hands.
7 Install the rear access panel.
1. Ensure that all required cables are
installed.
2. Insert the two dowels on the rear
access panel into the dowel holes
on the rack, and push the panel
up until it is secure.
The following figure shows the
appearance of the rear access
panel.