Other Problems - Canon iPF6300 User Manual

Troubleshooting

Other problems

The printer does not go on ........................................................................................................................ 904
If the Printer Makes a Strange Sound ....................................................................................................... 904
Messages advising to check the maintenance cartridge are not cleared .................................................. 904
The printer consumes a lot of ink .............................................................................................................. 905
Ink Level Detection .................................................................................................................................... 905
The printer does not go on
The printer is unplugged.
The specified voltage is not
supplied.
If the Printer Makes a Strange Sound
Cause
The printer
makes a
sound during
operation.
11
904
Messages advising to check the maintenance cartridge are not cleared
The printer has not detected the new Maintenance Cartridge that
was used to replace the old one.
The printer does not go on
> Other problems >
Cause
Plug the power cord into the outlet, and then turn on the printer.
Check the voltage of the outlet and breaker. Use a power source that conforms to
the printer specifications.
(See "Specifications.")
The following sounds do not indicate a problem with the printer.
•
There is a sound of suction from the Platen.
To prevent paper from rising, paper is held against the Platen by suction from Vacuum holes
under it.
•
Roll paper makes a fluttering sound during printing.
There may be a fluttering sound when large paper is advanced.
•
You suddenly hear the sound of cleaning operations.
At regular intervals, for printer maintenance, cleaning operations will begin automatically, even
if the printer is in Sleep mode.
•
You suddenly hear the sound of ink agitation.
At regular intervals, to ensure optimal printing quality, the ink is agitated automatically, even if
the printer is in Sleep mode. Ink agitation takes about 30 seconds.
The ink is also agitated automatically under the following conditions. Note that other opera-
tions are not possible while "Agitating" is displayed on the control panel.
•
After the printer is turned on
•
After data transmission
•
After ink tank replacement
In other cases, contact your Canon dealer.
Cause
Corrective Action
→P.798
Corrective Action
Corrective Action
Remove the new Maintenance Cartridge you
have just installed and insert it again firmly.
Restart the printer.
iPF6300