ABB i-bus KNX Product Manual page 36

Function of E2
Function of E2
Switch
One-panel blind operation
One-panel dimming
operation
Blind down
Dimming darker
Function of E3
Function of E3
Switch
One-panel blind operation
One-panel dimming
operation
Temperature sensor*
*The measured actual value is sent by object 2.
5.4.2 E 1...E3 as switching inputs
4 2 B
If an input has been parameterised as a switch input, switches can also be used as
buttons. The status of the relevant object (obj. 9...11) is switched according to the
p arameterisation .
H U U H
ON / OFF with switch
Parameter page
Input E1(E2, E3)
ON / OFF with button (see surge relay)
Parameter page
Input E1(E2, E3)
See above: O verview: Function of the objects 9 .. 14.
H U
Object 11
sends the switch status of
the E2 input
Sends commands for
step/stop or slat positioning
Sends on/off commands to
the dimmer
Fixed setting if E1 is parameterised on Blind up.
See previous table:Function of E1
Fixed setting if E1 is parameterised on Dimming
brighter.
See previous table:Function of E1
Object 13
sends the switch status of
the E2 input
Sends commands for
step/stop or slat positioning
Sends on/off commands to
the dimmer
Not used
Parameters
Reaction to the contact closing
Reaction to the contact opening
Parameters
Reaction to the contact closing
Reaction to the contact opening
Function
Object 12
Not used
Sends up/down command
to blind
Sends 4 bit dimming
commands
Function
Object 14
Not used
Sends up/down command
to blind
Sends 4 bit dimming
commands
Not used
Setting
On
Off
Setting
Circ
none
U
36