GE D90 Plus Instruction Manual page 397

CHAPTER 7: PROTECTION
Protection virtual output actual values
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 327: Protection virtual output settings
The following settings are available for each protection virtual output. If not assigned, the
virtual output is forced to off (logic 0).
ID
Range: up to 12 alphanumeric characters
Default: Virt Op 1
This setting specifies an identifier that can be assigned to each protection virtual output.
Events
Range: Enabled, Disabled
Default: Disabled
When this setting is "Enabled," every change in the protection virtual output state
triggers an event in the sequence of events recorder.
Select the Actual Values > Protection > Protection Inputs/Outputs > Virtual Outputs
menu to open the protection virtual outputs actual values window.
Figure 328: Protection virtual output actual values
The following actual values are available for all configured protection virtual outputs.
Name
Range: up to 12 alphanumeric characters
This value displays the programmed
PROTECTION INPUTS AND OUTPUTS
ID for the corresponding protection virtual output.
387