GE T60 Instruction Manual page 733

APPENDIX G
Table G–3: MAJOR UPDATES FOR T60 MANUAL REVISION Z1 (Sheet 2 of 2)
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
-- -- Add
1-1 1-1 Add
1-5 1-5 Update
2-12 2-12 Update
5-25 5-25 Add
5-103 5-103 Update
5-107 5-107 Update
5-282 5-282 Add
Table G–4: MAJOR UPDATES FOR T60 MANUAL REVISION Y3
PAGE PAGE CHANGE
(Y2) (Y3)
-- xi Add
5-90 5-90 Add
Table G–5: MAJOR UPDATES FOR T60 MANUAL REVISION Y2
PAGE PAGE CHANGE
(Y1) (Y2)
All All Update
All All Delete
1-1 1-1 Update
3-8 3-8 Update
Table G–6: MAJOR UPDATES FOR T60 MANUAL REVISION Y1 (Sheet 1 of 3)
PAGE PAGE CHANGE
(X2) (Y1)
All All Delete
Title Title Update
1-1 1-1 Update
2- 2- Add
2- 2- Delete
2-10 2-10 Delete
2-12 2-12 Update
2-21 2-21 Update
3-10 3-10 Update
GE Multilin
DESCRIPTION
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added CT failure feature to Table 2-2 Other Device Functions, to chapter 5 Settings > Control
Elements > Monitoring Elements > CT Failure Detector, and Appendix B table F124 List of
Elements as bitmask element 246 CT Failure
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-28 and 5-29 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-30 Disconnect Switch Scheme Logic
Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
Added a reference to the T35/T60 Reference Winding Selection and CT Ratio Mismatch
Application Note in section 5.4.4b General Transformer Settings, specifically the Reference
Winding setting
DESCRIPTION
Minor changes throughout document
Deleted CPU options U and V
Updated Figure 1-1 Rear Nameplate
Updated Figure 3-10 Rear Terminal View
DESCRIPTION
Deleted content pertaining to Ethernet switch
Changed part numbers. Updated address and contact information.
Updated address and contact information
Added CPU options T, U, and V to order code table
Removed E, G, H, J, S from CPU options from order code tables
Deleted 9S, 2S, 2T from replacement module order code Tables 2-7 and 2-8
Changed number of phase distance and ground distance zones to 5 in Protection Elements
section 2.2.1
Updated Ethernet fiber table in section 2.2.8 Communications
Updated Figure 3-12 Typical Wiring Diagram
T60 Transformer Protection System
G.1 CHANGE NOTES
G
G-3