Drive Shaft Boot Inspection; Wheel And Hub Torque Table; Wheel Removal; Transmission - Polaris RZR XP 1000 Service Manual

Drive Shaft Boot Inspection

Inspect the front and rear drive shaft boots
damage, tears, wear or leaking grease. If the boots
exhibit any of these symptoms, they should be replaced.
Check to see the boot clamps
Refer to DRIVE SHAFT CV JOINT / BOOT
REPLACEMENT , page
replacement.
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
for
1
are properly positioned.
for drive shaft boot
© Copyright 2014 Polaris Industries Inc.

Wheel and Hub Torque Table

ITEM
Wheel Nuts
(Cast Aluminum Wheels)
Hub Retaining Nuts
(Front and Rear)
Beadlock Screws
NOTE: Do not lubricate the stud or the lug nut.

Wheel Removal

1. Position the vehicle on a level surface.
2. Place the transmission in PARK and stop the engine.
3. Loosen the wheel nuts slightly. If wheel hub removal
is required, remove the wheel cap, cotter pin and
loosen the hub nut slightly.
4. Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
5. Remove the wheel nuts and remove the wheel.
MAINTENANCE
SPECIFICATION
120 ft-lbs (163 Nm)
110 ft-lbs (149 Nm)
Step 1: 24 in-lbs (3 Nm)
Step 2: 7 ft-lbs (10 Nm)
2.31
2