Pedal Position Sensor (Pps); Operation Overview; Location; Pps Test - Polaris RZR XP 1000 Service Manual

PEDAL POSITION SENSOR (PPS)

Operation Overview

NOTE: DO NOT attempt to service the PPS. The PPS
is a non-serviceable component and can only be
tested using Digital Wrench®. If the PPS is faulty, the
entire throttle pedal assembly must be replaced.
Mounted to the throttle pedal assembly, the PPS acts as
a throttle position sensor. The PPS provides throttle
pedal position to the Electronic Control Unit (ECU) to
increase or decrease engine RPM using the Electronic
Throttle Control (ETC). The PPS is the primary input
used to control engine speed during vehicle operation.

Location

The ETC switch is located in the drivers foot control
1
area, mounted on the top of the throttle pedal assembly.
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

PPS Test

The PPS can be tested utilizing Digital Wrench® by
verifying that throttle position readout varies as the pedal
is pressed. Reference the Data Display section and be
sure Throttle Position is displayed. With the ignition key
on for at least 15 seconds and engine not running, the
Throttle Position will read approximately 9.6% when the
pedal is released. With the pedal fully depressed, the
Throttle Position will vary depending on what gear you
have selected.
The Pedal Position Sensor is calibrated to the throttle
pedal. If the PPS is faulty, the throttle pedal assembly
must be replaced (see Chapter 4 – PPS Replacement,
page 4.37).

PPS Replacement

NOTE: The PPS is calibrated to the throttle pedal. If
the PPS is faulty, the throttle pedal assembly must
be replaced.
1. Disconnect the PPS harness connection
2. Remove the drivers seat and disconnect the
© Copyright 2014 Polaris Industries Inc.
• High/Neutral/Park/Invalid ≈ 70%.
• Low ≈ 60%
• Reverse ≈ 32%
on the throttle pedal.
negative (-) battery cable.
FUEL SYSTEM
located
4.37
4