Polaris RZR XP 1000 Service Manual page 303

16. Torque the locking screw to specification.
Snorkel Locking Screw:
10 ft-lb (14 Nm)
Transmission Assembly
NOTE: The snorkel shaft and pinion shaft must
be installed prior to transmission assembly. The
snorkel shaft cannot
assembling the transmission.
17. Clean both transmission case halves thoroughly.
Inspect case half mating surfaces for damage.
18. Install shift fork (S) and torsion spring into
transmission housing as an assembly. Load spring
as shown in image below
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
be installed after
© Copyright 2014 Polaris Industries Inc.
19. Apply Loctite ® 242 ™ to two screws (T) and install with
retaining plates over
specification.
Shift Fork Screws:
10 ft-lb (14 Nm)
20. Slide engagement dog (U) onto retaining pins of shift
fork.
TRANSMISSION
shift fork. Torque to
6.45
6