Set Up Analog Output - ABB COMMANDER 1900 Series Programming Manual

...3.7 Set Up Analog Output

SEt UP
ANALOG
SELECt
POSN–1
POSN–x
NONE
NONE
OP–SrC
PV–1
OP–2
NONE
NONE
rNG–HI
––––
PFb
or
OP
rNG–LO
––––
HI–OP
––––
SELECt
LO–OP
––
Page Header – Set Up Analog Output
To advance to
Digital Inputs Page
Select Analog Output
Select the analog output position to be programmed. The selections in this frame relate to the
number of fitted modules with analog output.
Example – Output 1 is the analog output in position 1 (fitted on the main board), output 3 is the
analog output fitted in module position 3.
Note. In the remaining frames press the
Output Source
Select output source required. The selections in this frame correspond to the inputs (Process
Variable, Set Point and Position Feedback) and controller outputs available.
Retransmission Range High
Set the engineering range value (in engineering units) at which maximum output is required.
Retransmission Range Low
Set the engineering range value (in engineering units) at which minimum output is required.
Output Range High
Set the maximum current output required for the
2.0 and 20.0mA.
Output Range Low
Set the minimum current output required for the
and 20.0mA.
Return to
Select Analog Output
3 BASIC CONFIGURATION LEVEL...
press the switch.
switch to view the analog output selected.
Retransmission Range
Retransmission Range
frame.
programmed between
programmed between 2.0
21