Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly; Paper Is Not Cut - Canon imagePROGRAF iPF6400SE User Manual

iPF6400SE
6
Fold an A4 sheet lengthwise four times and insert it
through the gap of the Back Cover. Push the scrap out to-
ward the Platen.
7
Remove the scrap when it is pushed out onto the Platen.
8
If any scraps remain inside the paper feed slot, repeat steps 6 and 7.
9
Close the Top Cover.
• If "Press OK and remove any remaining fragments of paper." is displayed after the message "Please
Wait..", fragments of paper may remain that have not been cleared away. Press OK and repeat the pro-
Note
cedure from step 5 to clear away all of the paper fragments from the paper feed slot.

Roll paper cannot be inserted into the paper feed slot

Roll paper cannot be inserted into the paper feed slot
The roll paper is warped.
Paper is jammed by the paper feed slot.
After a roll was advanced, the paper was manually pulled out by force,
closing the Paper Feed Slot.

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly
Cause
The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position be-
fore it is cut.
You are using paper that cannot be cut with the
Cutter Unit.
Cut Speed is not configured correctly in the
Control Panel menu.
During cutting, printed documents fall out at an
angle.

Paper is not cut

Paper is not cut
The printed document became caught on a foreign object by
the Output Tray, which lifted the document. The Cutter passed
under the paper.
User's Guide
Cause
Press the Load button and select the paper source.
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or
a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after
printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Cause
Roll paper cannot be inserted into the paper feed slot
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet, Fed Manually.")
Remove the roll and open the paper feed slot.
(See "Removing the Roll from the Printer.")
Corrective Action
Corrective Action
P.436
➔
Remove the foreign object by the Output Tray to enable the printer
to eject the printed document, keeping it level.
Corrective Action
P.571
➔
P.345
➔
P.350
➔
P.350
➔
Corrective Action
P.574
➔
577