Canon imagePROGRAF iPF6400SE User Manual page 480

Specifying the Printer's Frame Type
5
Select the IPv4 tab. In IP Address, enter the IP ad-
dress assigned to the printer, and then enter the sub-
net mask in Subnet Mask and the default gateway in
Gateway Address.
Important
6
Click Set.
7
Click OK after the Confirmation message is displayed.
8
Exit imagePROGRAF Device Setup Utility.
Specifying the frame type using the printer Control Panel
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Settings/Adj. tab (
Note
2
Press the OK button.
480
The Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4
Press ▲ or ▼ to select NetWare, and then press the OK button.
5
Press ▲ or ▼ to select NetWare, and then press the OK button.
• You must specify the IP address here to be able to configure NetWare protocol settings using Remo-
teUI.
).
• If the Tab Selection screen is not displayed, press the Menu button.
iPF6400SE
User's Guide