Canon imagePROGRAF iPF6400SE User Manual page 445

iPF6400SE
Adjust Feed Adj.
Printer Priority Quality
Adjust
Length
Adj Far Ed Feed
Mainte- Head Cleaning
nance
Nozzle Check
Replace P.head
Repl. maint cart
Clear remain pcs
Head Info
Clean Platen
Inter- EOP Timer
face
Setup
TCP/IP IPv4
User's Guide
Setting Item
Manual
Adjust- A:High
ment-
B:Standard/Draft
Print
Change A:High
Settings
B:Standard/Draft
IPv4 Mode
Proto- DHCP
col
BOOTP
RARP
IPv4 IP Address
Settings
Subnet Mask
Default G/W
Description, Instructions
Use this mode with highly transparent media or other pa-
per for which Auto(GenuinePpr) or Auto(OtherPaper)
cannot be used.
Print a test pattern for adjustment of the feed amount
based on the type of paper. (See "Manual Banding Adjust-
ment.")
P.522
➔
Print a test pattern for particular types of paper to com-
pensate for paper stretching or shrinkage, after which you
enter the amount of adjustment. (See "Adjusting Line
Length.")
P.524
➔
Displayed when you have selected Feed Priority > Adj.
Priority > Print Length.
Adjustment relative to the amount of stretching or shrink-
age of the current paper.
Enter either the adjustment results from AdjustmentPrint
or the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount
by choosing a higher adjustment value. For paper that
tends to shrink, decrease the feed amount by choosing a
lower adjustment value. (See "Adjusting Line
Length.")
P.524
➔
Choose Yes to adjust the feed amount for the trailing
edge.
Clean the Printhead. (See "Cleaning the Print-
head.")
P.539
➔
Choose Head Cleaning A if printing is faint, oddly col-
ored, or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or if
printing is not improved by Head Cleaning A.
Print a test pattern to check the nozzles.
Execute when replacing the Printhead. Follow the instruc-
tions displayed to complete the required procedure. (See
"Replacing the Printhead.")
P.540
➔
Not displayed during a warning message that the remain-
ing Maintenance Cartridge capacity is low.
Execute when replacing the Maintenance Cartridge. Fol-
low the instructions displayed to complete the required
procedure. (See "Replacing the Maintenance Car-
tridge.")
P.546
➔
This process is needed if there are any scraps left in the
Paper Feed Slot. (See "Clearing Jammed Paper (Paper
Feed Slot).")
P.576
➔
Indicates information about the printhead.
Move the Carriage in preparation for cleaning the Platen.
Specify the timeout period before cancellation of print jobs
that cannot be received by the printer.
Choose whether the printer IP address is configured auto-
matically or a static IP address is entered manually.
Specify the protocol used to configure the IP address au-
tomatically.
Specify the printer network information when using a stat-
ic IP address.
Enter the IP address assigned to the printer, as well as
the network subnet mask and default gateway.
Menu Settings
445