Choke Lever - Toro 04054 Operator's Manual

Figure 14
Parking Brake Latch
The parking brake latch (Figure 15) is used in conjunction
with the service brake and is located at the base of the service
brake. Fully engage the service brake and push the parking
brake knob to allow the service brake to rest on the parking
brake pin. Engage the service brake to release the parking
brake. You must release the brake before the traction drive
is engaged.
Figure 15
On/Off Switch
The on/off switch (Figure 13) is located on the top of the
control panel. Move the switch to the On position to start the
engine and the Off position to stop the engine.
Operator Presence Control (Optional)
If equipped, the operator presence control (Figure 13) is
located on the rear of the handle. Push the operator presence
control against the handle. If equipped, the operator presence
control must be engaged before moving the traction drive
lever or the engine will stop.
Reel Drive Lever
The reel drive lever (Figure 16) is located on the right front
corner of the machine. The lever has two positions: Engage
and Disengage. Move the lever outward to engage the reel or
inward to disengage the reel.
G016976
1. Reel drive lever

Choke Lever

The choke lever (Figure 17) is located on the left front of
the engine. The lever has two positions: Run and Choke.
Move the lever to the half–open position when starting a
cold engine. After the engine starts, move the lever to the
Run position.
G016977
1. Choke lever
Fuel Shut-Off Valve
The fuel shut-off valve (Figure 18) is located on the left
front of the engine near the choke lever. The valve has two
positions: Closed and Open. Move the lever up to the closed
position when storing or transporting the machine. Open the
valve before starting the engine by rotating the lever down.
The fuel cup is located below the shut off valve.
14
1
G016978
Figure 16
Figure 17
g018267