Jacking Points; Clearing The Cutting Cylinders - Toro 02750 Operator's Manual

1
2
3
1. Upper frame
2. Hand nuts, washers and
retaining bolts
WARNING
When in the raised position, both retaining bolt
assemblies must be installed and fully tightened to
ensure full rollover protection.
WARNING
Be careful lowering and raising the upper frame to
prevent entrapment of fingers between fixed part
and pivot part of the structure.
•
Keep all nuts, bolts and screws correctly torqued ensure
that the equipment is in safe working condition.
•
Replace worn or damaged parts for safety.
•
Ensure that the seat belt and mountings are in safe
working order.
•
Wear the seat belt when the upper frame is raised and no
seat belt when the roll bar is lowered.
Important: The upper frame is an integral and effective
safety device. Keep the upper frame in the raised
position when operating the machine. Lower the upper
frame temporarily only when absolutely necessary.

Jacking Points

Note: Use jack stands to support the machine when required.
•
Front—under the front arm mount.
•
Rear—rear strapping hook.
Figure 30
3. Lower holes

Clearing the Cutting Cylinders

WARNING
Never attempt to rotate the cutting cylinders by
hand.
• There may be some residual pressure in the
hydraulic system which could cause injury
through sudden movement of the cylinder(s)
when the blockage is released.
• Always wear protective gloves and use a suitable
strong wooden instrument.
• Ensure that the wooden instrument will fit
between the blades and through the cylinder
and is long enough to provide sufficient leverage
to release the blockage.
G014436
1. Stop the machine on level ground.
2. Apply the parking brake and disengage all drives.
3. Lower the cutting units to the ground or securely lock
in the designated transport positions.
4. Stop the engine and remove the ignition key to isolate
all power sources and check that they are stopped.
5. Release all stored energy devices.
6. Check that all moving parts are stationary.
7. Using a suitable strong wooden instrument, remove
the blockage. Make sure that the wooden instrument is
properly supported in the cylinder and avoid the use of
excessive force to prevent damage.
8. Ensure that the wooden instrument is removed from
the cutting cylinder before restarting the power source.
9. Repair or adjust the cylinder if required.
27