Changing The Engine Oil And Filter - Toro 02750 Operator's Manual

3. Remove the dipstick, wipe it clean, and install it
35).
Figure 35
1. Dipstick
4. Remove dipstick and check oil level on dipstick.
The oil level should be up to the F
5. If the oil level is below the F
cap (Figure 36) and add oil until level reaches the F
mark on dipstick.
Important: Do not overfill.
1
Figure 36
1. Oil fill cap
Important: Be sure to keep the engine oil level
between the upper and lower limits on the oil
gauge. Engine failure may occur as a result of over
filling or under filling the engine oil.
6. Install the oil fill cap.
7. Close engine cover and secure with the latches.
(Figure
1
G012280
mark.
ULL
mark, remove the fill
ULL
ULL
G012281
Changing the Engine Oil and
Filter
Service Interval: After the first 50 hours
Every 150 hours
1. Remove the drain plug
into a drain pan.
1. Oil drain plug
2. When the oil stops, install the drain plug.
3. Remove the oil filter
1
1. Oil filter
4. Apply a light coat of clean oil to the new filter seal.
5. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn.
Important: Do not overtighten the filter.
6. Add oil to the crankcase; refer to
Engine-Oil Level (page
35
(Figure 37) and let the oil flow
1
Figure 37
(Figure 38).
Figure 38
Checking the
34).
G012305
G012306