Understanding The Operator Presence Controls - Toro 02750 Operator's Manual

4. Move the locking latch handle toward the front of the
machine until the latch hooks clear the locking bar and
raise the platform (Figure
Note: The gas spring will provide assistance.
1. Toward front of the
machine
2. Locking latch handle
Securing the Platform
1. Lower the platform carefully.
Note: The gas spring will provide assistance.
2. Move the locking latch handle toward the front of
the machine as the platform nears the fully lowered
position (Figure 24).
Note: This will ensure that the latch hooks clear the
locking bar.
3. Fully lower the platform and move the locking latch
handle toward the rear of the machine until the latch
hooks fully engage the locking bar
4. Install the padlock to secure the locking latch handle
in place.
24).
Figure 24
3. Toward rear of machine
4. Tool tray
(Figure 24).
Understanding the Operator
Presence Controls
Note: The engine stops if the operator leaves the seat
without engaging the parking brake.
Engine Start Lockout: The engine can only be started
when the forward/reverse travel pedal is in the N
position, the cutting unit drive switch is in the O
and the parking brake is engaged. When these circumstances
are satisfied, switches are activated, permitting the engine to
be started.
Engine Run Interlock: After starting the engine, you must
be seated before releasing the parking brake for the engine to
continue to run.
Cutting Cylinder Drive Lockout: The drive to the cutting
cylinders is only possible when you are seated. If you raise
off the seat for a period of more than 1 second, a switch
activates and the drive to the cutting cylinders automatically
disengages. To engage drive to the cutting cylinders, return
to the seat, then operate the cutting unit drive switch to the
O position before moving it back to the O
FF
you rise off the seat for a brief moment during normal work,
drive to the cutting cylinders is not affected.
The engine can only be started with the cutting-unit drive
switch in the O position.
FF
WARNING
Do not operate the turf machine if the operator
presence controls are malfunctioning in any way.
Always replace damaged or worn parts and check
that they function correctly before operating the
machine.
CAUTION
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
23
EUTRAL
position
FF
position. If
N