Toro 02821 Installation Instructions

Floating 200 mm (8in) Cutting Unit
5-Plex Mower
Model No. 02821
This product contains a chemical or chemicals known to the State of California to
Introduction
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
safety and operation training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Toro Distributor or
Toro Customer Service and have the model number of your
product ready.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Nut (16 mm)
Washer (16 mm)
Pin (8 mm)
Grease fitting
Washer (10 mm)
Hex nut (10 mm)
Pin (25 mm)
Split pin
Float-casting pivot
Bushing (30 x 20 mm)
Bushing (25 x 25 mm)
Carriage bolt (M10 x 8.8 mm)
Roller
Right wing-head stop
Left wing-head stop
Bolt (M16 x 120 mm)
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
5
14
5
10
4
4
5
2
5
10
10
4
2
1
1
5
Register at www.Toro.com.
This product complies with all relevant European directives.
For details, please see the Declaration of Incorporation (DOI)
at the back of this publication.
Contents
Introduction .................................................................. 1
Setup ............................................................................ 1
Preparing the Machine ............................................. 2
Preparing the Cutting Units ...................................... 2
Installing the Kit ..................................................... 3
Install the kit.
Original Instructions (EN) All Rights Reserved *3412-332* A
Printed in the USA
Form No. 3412-332 Rev A
Installation Instructions
Use