Operation; Think Safety First; Checking The Engine-Oil Level; Adding Fuel - Toro 02750 Operator's Manual

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Lower the cutting units to the ground, set the
parking brake, and remove the key from the ignition
switch before servicing or making adjustments to
the machine.

Think Safety First

Carefully read all safety instructions and symbols in the
safety section. Knowing this information could help you or
bystanders avoid injury.
DANGER
Operating on wet grass or steep slopes can cause
sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death, or
drowning.
There is no rollover protection when the roll bar is
down.
Always keep the roll bar in the fully raised and
locked position and use the seat belt.
Read and follow the rollover protection instructions
and warnings.
To avoid loss of control and possibility of rollover:
• Do not operate near drop-offs or near water.
• Do not operate on slopes greater than 18 degrees.
• Reduce speed and use extreme caution on
slopes.
• Avoid sudden turns or rapid speed changes.
CAUTION
This machine produces sound levels that can cause
hearing loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
CAUTION
Long-term exposure to vibration while operating
the machine may cause some numbness in the
hands and wrists.
Wear gloves that dampen the vibration whenever
you operate the machine for an extended period of
time.
The use of protective equipment for eyes, ears, hands, feet,
and head is recommended.
1
1. Wear safety glasses.

Checking the Engine-Oil Level

The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started. Refer to Checking the Engine-Oil Level (page

Adding Fuel

Use only clean, fresh diesel fuel with low (<500 ppm) or ultra
low (<15 ppm) sulfur content. The minimum cetane rating
should be 40. Purchase fuel in quantities that can be used
within 180 days to ensure fuel freshness.
Fuel tank capacity: 70 L (18.5 US gallons)
Use summer-grade diesel fuel (No. 2-D) at temperatures
above -7° C (20° F) and winter-grade (No. 1-D or No.
1-D/2-D blend) below that temperature.
Using summer-grade fuel above -7° C (20° F) will contribute
toward longer fuel pump life and increased power compared
to winter grade fuel.
Using winter-grade fuel at lower temperatures provides lower
flash point and cold flow characteristics which will ease
starting and reduce fuel filter plugging.
Important: Do not use kerosene or gasoline instead of
diesel fuel. Failure to observe this caution will damage
the engine.
21
G009027
Figure 23
2. Wear hearing protection.
2
34).