Adjust Rubber Flap; Operation; Controls - Toro 07052 Operator's Manual

4. Repeat procedure on opposite side of machine.
5. Retighten adjustment lock nut.

Adjust Rubber Flap

For best debris pick up results, metal portion of front flap
should be vertical to ground.
1. Move flat lever forward to lower flat.
2
1
Figure 13
1. Rubber flap
2. Loosen jam nut on top of stop and rotate adjustment
bolt up or down until flap is vertical to ground.
Figure 14
1. Adjustment bolt
3. Tighten jam nut to secure adjustment.
Note: Flap may be positioned in raised position when
picking up large amounts of leaves.
2. Metal edge
1
2
2. Stop
14

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Controls

Flap Lever
Move flap lever (Fig. 15) downward to engaged position
and upward for disengaged position. Move lever to upward
position when transporting machine.
Reel Lever
Push reel lever (Fig. 15) forward to raise flex tip reel. To
lower flex reel, push lever forward until catch releases, then
push to rear until lever hits STOP. Move lever to raised
position when sweeper is not in operation, when storing
machine or when transporting machine.
1
2
Figure 15
1. Flap lever
Clutch Handle
The clutch handle (Fig. 16) is located on the clutch
housing. Push outward on clutch handle to engage and
inward to disengage (Model 07050 only).
Important Move sweeper as quickly as possible after
lowering reel lever and engaging clutch lever to prevent
turf damage.
2. Reel lever