Before Operating; Check Engine Oil; Check Clutch Housing Oil - Toro 07052 Operator's Manual

2. On Model 07052 only, disconnect drive shaft quick
coupler from prime mover PTO shaft.
3. Insert castor wheel onto jack tube.
4. Raise sweeper jack handle and lower caster wheel to
ground.
5. Continue to raise sweeper with jack until hair pin cotter
and hitch pin can be removed from hitch.

Before Operating

Caution
Before servicing or making adjustments to the
machine, stop engine(s), disengage clutch and
disconnect PTO (If so equipped) from prime
mover.

Check Engine Oil

(Model 07050 only)
The engine is shipped with approximately 2 quarts
(w/filter) of oil in the crankcase; however, level of oil must
be checked before and after the engine is first started.
1. Position machine on a level surface.
2. Remove dipstick and wipe it with a clean rag. Insert
dipstick into tube and make sure it is seated fully.
Remove dipstick from tube and check level of oil. If oil
level is low, remove filler cap and add enough oil to
raise level to "FULL" mark on dipstick.
1
Figure 6
1. Dipstick
1
1. Filler cap
3. The engine uses any high-quality detergent oil having
the American Petroleum Institute -API- "service
classification" SG, SH or SJ. Oil viscosity (weight) is
selected according to the anticipated ambient
temperature.
Temperature / viscosity recommendations are:
Above 0 F (–20 C) – Use 10W–30 or 10W–40.
Below 32 F (0 C) – Use 5W–20 or 5W–30.
4. Pour oil into fill opening until the oil level is up to the
"FULL" mark on the dipstick. Add the oil slowly and
check the level often during this process. DO NOT
OVERFILL
Important
Check level of oil every 8 operating hours
or daily. Initially, change oil after the first 5 hours of
operation; thereafter, under normal conditions, change oil
every 100 hours and filter every 200 hours. However,
change oil more frequently when engine is operated in
extremely dusty or dirty conditions.
5. Install the dipstick firmly in place.

Check Clutch Housing Oil

(Model 07050 only)
The clutch housing uses any high-quality detergent oil
having the American Petroleum Institute -API- "service
classification" SE, SF, SG or SH. Recommended viscosity
(weight) is SAE 30.
1. Position machine on a level surface.
2. Remove oil level plug on side of clutch housing.
11
Figure 7