Mount Sweeper To Prime Mover - Toro 07052 Operator's Manual

Warning
Battery terminals or metal tools could short
against metal tractor components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the tractor.
Do not allow metal tools to short between the
battery terminals and metal parts of the tractor.
2. Attach the negative cable (wire from engine block) to
the negative (–) terminal of the battery.
Warning
Incorrect battery cable routing could damage the
tractor and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
Always connect the positive (red) battery cable
before connecting the negative (black) cable.
3. Attach the positive cable (wire from ignition switch) to
the positive (+) terminal.
4. Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5. Install battery cover and secure with springs.
Mount Sweeper To Prime
Mover
To assure proper debris pickup, make sure sweeper frame is
parallel with the ground.
1. Position sweeper on a flat, level surface.
2. Insert sweeper jack caster wheel onto sweeper end of
jack tube.
3. Adjust sweeper jack so distance from top of frame to
ground is approximately 23–1/2" (Fig. 2).
4. Back prime mover up to sweeper.
5. Adjust sweeper hitch tongue to same level as hitch of
prime mover as follows:
Model 07050
Remove capscrews and locknuts securing hitch tongue
to frame (Fig. 2).
Raise or lower hitch tongue to position approximately
level with prime move hitch and secure with (2)
capscrews and locknuts.
3
2
Figure 2
1. Sweeper jack
2. Hitch tongue
(Model 07050)
Model 07052
Remove front and rear capscrews and locknuts securing
hitch tongue to frame (Fig. 3).
Raise or lower hitch tongue to position it approximately
level with prime move hitch and secure with (2)
capscrews and locknuts. The main frame should be
parallel with the ground surface about 23–1/2" when
attached to tractor.
9
1
23–1/2"
3. Adjusting screws