Related Manuals for Toro 07081
Summary of Contents for Toro 07081
- Page 1 Form No. 3350–959 Rev C Finger Deck Versa Vac Model No. 07081—Serial No. 240000001 and Up Operator’s Manual English (EN)
-
Page 2: Table Of Contents
....... Dealer or Toro Customer Service and have the model and serial numbers of your product ready. -
Page 3: Safety
Toro replacement parts and potential of permanent hearing damage. accessories to keep the machine all Toro. Never use • Using the machine demands attention. To prevent loss “will-fit” replacement parts and accessories made by of control: other manufacturers. -
Page 4: Safety And Instruction Decals
Safety and Instruction Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 106-0178 105-4586 1. Entanglement hazard, belt—stay away from moving parts. Do not operate the machine with the shields or guards removed;... -
Page 5: Specifications
Specifications General Specifications The Finger Deck is used with the Toro Versa Vac. The primary function is to General Description facilitate debris removal from large turf areas. Main Frame One piece–welded frame of 10 and 12 gauge formed steel. Four casters with adjustable height Support Six 1/2 inch spacers per caster (3 inch of adjustment by 1/2 inch intervals). -
Page 6: Setup
Operator’s Manual Read before operating the machine. Parts Catalog Registration card Fill out and return to Toro. Mount Finger Deck 4. Install canvas ring around the lip on the Versa Vac and deck openings (Fig. 3). 1. Roll the deck under the Versa Vac. Make sure hydraulic motor is on the left side. -
Page 7: Before Operating
Before Operating 2. Remove or add ”C” shaped spacers to the spindle shaft, below the castor arm, to get the desired height. 3. Place all remaining spacers on the spindle shaft above Note: Determine the left and right sides of the machine the caster arm. -
Page 8: Operation
Operation Inspection And Cleanup After Operation Note: Determine the left and right sides of the machine When operation has been completed, thoroughly clean and from the normal operating position. wash the deck. After cleaning, it is recommended that the machine be inspected for possible damage to all mechanical Tips components. -
Page 9: Maintenance
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Greasing the Deck The deck has 10 grease fittings that must be lubricated regularly with No. 2 General Purpose Lithium Base Grease. The grease fitting locations and quantities are: •... -
Page 10: Replacing Finger Belts
Replacing Finger Belts 2. On back side of frame, loosen capscrew securing belt tensioner to frame (Fig. 9). 1. Loosen nuts and washers securing finger pinchers to rotor (Fig. 10 & 11). 2. Remove old belt fingers. 3. Install new belt fingers. Belt fingers to extend from finger pinchers approximately 4 inches (Fig. -
Page 12: The Toro General Commercial Products Warranty
Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfi ed with your Distributor’s service or have diffi...