Connecting Drive Shaft To Prime Mover Pto Shaft; Removing Sweeper From Prime Mover - Toro 07052 Operator's Manual

23–1/2"
1
2
Figure 3
1. Hitch tongue
(Model 07052)
2. Front adjustment
capscrew
6. Secure sweeper hitch tongue to prime mover hitch with
hitch pin and hair pin cotter.
7. Raise sweeper jack caster wheel tube up to frame and
fold handle down.
8. Store caster wheel in compartment on left side of
machine in front of hopper.
Important
After first ten hours of operation, re–tighten
capscrews and locknuts securing hitch tongue to sweeper.
Connecting Drive Shaft to
Prime Mover PTO Shaft
(Model 07052 only)
Important
Mating tractor must have the dimensions
shown in figure 4. Do not operate sweeper with tractor of
different dimensions.
Important The distance ("A" Figure 4) between the
hole in the tractor hitch and the point where the drive shaft
coupler attaches to the prime mover, P.T.O. shaft must be
14'' plus or minus 1/2". If 14" is not attained, an
adjustment to the tractor hitch must be made before
operating sweeper.
Warning
If "B" dimension (Fig. 4) is less than 3", extreme
caution must be used when tractor and sweeper
unit crests tops of steep hills.
3
3. Rear adjustment
capscrew
10
Figure 4
1. Attach drive shaft quick disconnect to P.T.O. shaft of
prime mover.
Important A shield should be provided on tractor to
cover drive shaft universal joint. Do not operate drive shaft
without this shield in place.
1
Figure 5
1. Drive shaft quick coupler
Warning
This sweeper is designed for a 540 RPM P.T.O.
shaft only. Do not operate with a 1000 RPM P.T.O.
tractor.
Removing Sweeper From
Prime Mover
Warning
Always empty sweeper hopper before
disconnecting hopper from prime mover or
sweeper may tip backwards and cause injury.
1. Park sweeper on a level surface and block wheels.
A = 13–1/2" TO 14–l/2"
B = 2–3/4" TO 11–1/2''
C = 7–1/4" TO 17–1/4"
A
P.T.O. SHAFT
(540 RPM)
B
C
DRAW BAR