Changing Rubber Flap; Cleaning Blower Housing - Toro 07052 Operator's Manual

2. Insert clutch adjusting plates onto clutch handle.
3. Position adjusting plates on clutch handle so distance
between center of square hole in plates and center of
clutch lever pivot shaft is 12 inches. Tighten fasteners
securing adjusting plates to clutch lever.
3
1
4
2
Figure 31
1. Clutch lever
2. Clutch lever pivot shaft
4. Insert torque wrench into square holes in adjusting
plates and check to make sure torque is 45–50 pounds.
5. Remove adjusting plates and store in a memorable
place.
To adjust clutch proceed as follows:
1. Remove clutch cover plate.
2. Loosen clutch locking tab.
3. Turn adjusting ring clockwise until proper adjustment is
attained.
4. Tighten clutch locking tab.
5. Insert torque wrench into square holes in adjusting
plates and check to make sure torque is 45–50 pounds.
6. Install cover plate.
12.00"
3. Clutch adjusting plates
4. Clutch cover plate
21
Warning
Do not operate P.T.O. with clutch cover plate
removed as rotating parts can cause injury.

Changing Rubber Flap

Replace rubber flap when it becomes worn or damaged.
Caution
Change rubber flap on a flat, level surface and
block wheels to prevent sweeper from rolling.
Failure to do so may result in personal injury.
1. Remove (10) capscrews, washers, and nuts mounting
flap and flap retainer.
2
1
Figure 32
1. Rubber flap
2. Replace with new rubber flap and fasten securely.

Cleaning Blower Housing

Warning
Before removing any debris from blower housing,
disengage clutch, disengage P.T.O. drive, stop
engine(s) and make certain all moving parts have
stopped or personal injury may occur.
2. Flap retainer