Table of Contents
Advertisement
Maintenance
Note: Determine the left and right sides of the machine
from the normal operating position.
Greasing the Deck
The deck has 10 grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
The grease fitting locations and quantities are:
• Caster wheel (2 ea.) (Fig. 6)
• Finger rotor bearings (2) (Fig. 7)
Important
Lubricating the deck immediately after
washing helps purge water out of the bearings and increases
bearing life.
1. Wipe each grease fitting with a clean rag.
2. Wipe excess grease away.
Figure 6
Figure 7
Adjusting the Drive Belt
Make sure belt is properly tensioned to ensure proper
operation of the machine and unnecessary wear. Check belt
frequently.
Note: Check/adjust the belt tension after the first 20 hours
of operation.
1. Remove the fasteners securing the motor shield to the
deck frame (Fig. 8). Remove the shield.
1
Figure 8
1. Drive shield
9
Advertisement
Table of Contents
