Installing The Seat; Installing The Motion Control Levers - Toro Z400 Series Z Master Setup Instructions

Figure 11
5

Installing the Seat

No Parts Required
Procedure
1. Remove the bolt and nut from the seat frame.
2. Remove the nuts from the studs under the seat.
3. Secure the seat rod to the seat with the bolt and nut.
4. Install the seat to the seat frame with the previously
removed nuts.
5. Install the seat rod to the seat frame.
6
Installing the Motion Control
Levers
Parts needed for this procedure:
1 Right control lever
1 Left control lever
4 Bolt (3/8 x 1 inch) (2 are assembled)
4 Curved washer (3/8 inch) (2 are assembled)
Procedure
1. Rotate the motion control levers to the upright
position.
2. Loosely install the control levers on the outside of
the posts, using 4 bolts and 4 curved washers.
5
Figure 12
Figure 13