Checking The Tire Pressure - Toro Z400 Series Z Master Setup Instructions

Procedure
14
1
Removing Parts from the Crate
No Parts Required
Procedure
Remove the tires, the seat and the parts for the ROPS
from the shipping crate.
2

Checking the Tire Pressure

No Parts Required
Procedure
Pressure: 13 psi (90 kPa)
1. For Estate Models only, check the air pressure in the
front tires.
Note: If there is no valve stem located in the front
tires, then it is a semi-pneumatic tire and does not
need to be checked.
2. Check the air pressure in the rear tires.
Description
Operator's Manual
Parts Catalog
Engine Owner's Manual
Registration Card
Safety Video
Key
Figure 1
Qty.
1
1
1
Delivering the machine to the customer.
1
1
2
3
Raising the Machine Up and
Installing the Drive Wheels
Parts needed for this procedure:
2 Rear wheels
Procedure
1. Remove the screws holding the right angle retaining
plate to the crate.
2. Raise the back of the machine up and support it with
jack-stands.
2
Use
Figure 2