Adding Fuel To The Machine; Charging The Battery - Toro Z400 Series Z Master Setup Instructions

Note: Install the control levers in the top and
middle holes for the high position or the middle and
bottom holes for the low position, as desired.
Figure 14
3. Raise the levers and align them together in the
neutral position and tighten the bolts.
Figure 15
Note: If the machine is not properly tracking, refer
to Adjusting the Tracking in your Operator's Manual.
7

Adding Fuel to the Machine

No Parts Required
Procedure
Add fuel to the machine before starting it. Refer to your
Operator's Manual. for the correct fuel and procedure.
8

Charging the Battery

No Parts Required
Procedure
Charging the battery produces gasses that can
explode and cause serious injury.
• Keep cigarettes, sparks and flames away
from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the battery
in an enclosed space.
Important: Do not run the machine with the
battery disconnected; electrical damage may occur
to the engine.
Charge the battery. Refer to the Operator's Manual for
instructions.
6