Lubrication; Greasing The Bearings And Bushings - Toro 30605 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours—Lubricate the grease
fittings. Also lubricate the grease fittings
after every washing of the machine.
Note: Use No. 2 general-purpose, lithium-based grease.
The grease fitting locations and quantities are as follows:
Traction Unit
•
Brake-pedal, pivot-shaft bearings (2)
•
Front- and rear-axle pivot bushings (2)
•
Steering-cylinder ball joints (2)
•
Tie-rod ball joints (2)
•
King-pin bushings (2)
The top fitting on the king pin should be lubricated
only annually (2 pumps).
Figure 33
Figure 34
(Figure 33)
(Figure 34)
(Figure 35)
(Figure 35)
(Figure 35).
Front Cutting Unit
•
Castor-fork-shaft bushings (2)
•
Spindle-shaft bearings (3)
Note: These bearings are located under the pulley.
•
Idler-arm-pivot bushings (2)
37
Figure 35
(Figure 36)
(Figure 37)
(Figure 37)
Figure 36