Setup; Greasing The Machine; Replacing The Warning Decal - Toro 30605 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Materials
Declaration of conformity
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Greasing the Machine

No Parts Required
Procedure
Before operating the machine, greased it to ensure proper
lubricating characteristics; refer to
and Bushings (page 37). Failure to properly grease the
machine will result in premature failure of critical parts.
Description
No parts required
Warning Decal
Greasing the Bearings
Qty.
–
1
Qty.
1 Review before operating machine
1 Use to reference engine information
1 Use to reference part numbers
1
Review before operating machine
1
2

Replacing the Warning Decal

Parts needed for this procedure:
1 Warning Decal
Procedure
On machines requiring European CE compliance, replace the
old warning decal (part no. 117-2754) with the new warning
decal (part no. 117-2766).
15
Use
Grease the machine.
Used only on machines requiring
European CE compliance.
Use