Seat Adjustments - Toro 30605 Operator's Manual

the traction pedal to the N
machine at a slow speed.
Lift Switches
The lift switches (Figure
units. Press the switches forward to lower the cutting units
and backward to raise the cutting units. When starting the
machine, with the cutting units in the down position, press the
lift switch down to allow the cutting units to float and mow.
Note: The decks will not lower while in the high-speed range
and they will not raise or lower if the operator is out of the
seat when the engine is running. Also, the decks will lower
with the key in the O position and the operator in the seat.
N
Power Point
The power point (Figure 5) is used to power optional electrical
accessories.
g028454
1. Power point
Cruise-Control Switch
The cruise-control switch
position to maintain the desired ground speed. Pressing the
rear of the switch turns off the cruise control, the middle
position of the switch enables the cruise control function and
the front of the switch sets the desired ground speed.
Note: Pressing either brake pedal or moving the traction
pedal into the reverse position for 1 second also disengages
the pedal position.

Seat Adjustments

Fore-and-Aft-Adjusting Lever
Pull out on the lever to slide the seat fore or aft
Armrest-Adjusting Knob
Rotate the knob to adjust the armrest angle
position, and drive the
EUTRAL
4) raise and lower the cutting
1
2
Figure 5
2. Cruise-control switch
(Figure 5) locks in the pedal
(Figure
(Figure
Back-Adjusting Lever
Move the lever to adjust the back angle of the seat
Weight Gauge
This gauge indicates when the seat is adjusted to the weight
of the operator
the suspension within the range of the green region.
1. Weight gauge
2. Weight-adjusting lever
3. Fore-and-aft-adjusting
lever
Weight-Adjusting Lever
Adjust for operator weight
increase the air pressure and push down to decrease the air
pressure. The adjustment is correct when the weight gauge
is in the green region.
Using the InfoCenter LCD Display
The InfoCenter LCD display shows information about your
machine such as the operating status, various diagnostics
and other information about the machine
is a splash screen and main information screen of the
InfoCenter. You can switch between the splash screen and
main information screen, at any time, by pressing any of
the InfoCenter buttons and then selecting the appropriate
directional arrow.
6).
6).
17
(Figure 6). Adjust the height by positioning
Figure 6
4. Back-adjusting lever
5. Armrest adjusting knob
(not shown-located under
armrest)
(Figure 6). Pull up the lever to
(Figure 6).
(Figure 7) There