Toro 30605 Operator's Manual page 44

Figure 57
1. Check/drain plug
2. Place a drain pan under the planetary hub, remove the
plug, and allow the oil to drain.
3. Place a drain pan under the brake housing, remove the
drain plug, and allow the oil to drain
Figure 58
1. Drain plug
4. When all of the oil has drained from both locations,
install the plug in the brake housing.
5. Rotate the wheel until the open plug hole in the
planetary is at the 12 o'clock position.
6. Through the open hole, slowly fill the planetary with
0.5 L (22 oz) of high quality SAE 85W-140 wt. gear
lube.
Important: If the planetary fills before the 0.5 L
(22 oz) of oil is added, wait 1 hour or install the
plug and move the machine approximately 3 m (10
ft) to distribute the oil through the brake system.
Then remove the plug and add the remaining oil.
7. Install the plug.
8. Repeat the procedure on the opposite planetary/brake
assembly.
(Figure 58).
g020680
2. Brake housing
44