Accessing The Fuses; Drive System Maintenance; Adjusting The Traction Pedal Angle; Changing The Planetary-Gear Oil - Toro 30605 Operator's Manual

4. Slide the rubber boot over the positive terminal.
5. Close the battery cover.

Accessing the Fuses

The traction-unit fuses (Figure 53
located under the power center cover.
Remove the 2 Allen-head screws securing the power-center
cover to the frame and remove the cover
Figure 53
1. Power-center cover
Figure 54
1. Fuses
Figure 55
through Figure 55) are
(Figure 53).
2. Allen-head screws (2)
Drive System
Maintenance
Adjusting the Traction Pedal
Angle
You can adjust the traction pedal operating angle for
operating comfort.
1. Loosen the 2 nuts and bolts securing the left side of the
traction pedal to the bracket
1. Traction pedal
2. Pivot the pedal to the desired operating angle and
tighten the nuts
Changing the Planetary-Gear
Oil
Service Interval: After the first 200 hours
Every 800 hours
Use a high quality SAE 85W-140 gear lube.
1. With the machine on a level surface, position a wheel
so that 1 of the check plugs is at the lowest (6 o'clock)
position (Figure
43
(Figure 56).
Figure 56
2. Mounting nuts and bolts
(2)
(Figure 56)˙.
57).