Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Media and Additional Parts
Description
Operator's Manual
Engine operator's manual
Parts Catalog
Operator Training Material
1
Adjusting the ROPS
No Parts Required
Procedure
1. Remove the hairpin cotter pins and the pins from the
roll bar
(Figure
3).
2. Raise the roll bar to the upright position and install the
2 pins and secure them with the hairpin cotter pins
(Figure
3).
Note: If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove the
pins, lower the bar slowly, and secure it with the pins so
that it does not damage the hood.
Description
No parts required
No parts required
No parts required
Qty.
–
–
–
Qty.
1
Read the manual before operating the machine.
1
Read the manual before operating the machine.
1
Use the Parts Catalog to reference part numbers.
1
Review before operating machine
1. Roll bar
2. Pin
9
Use
Adjust the ROPS.
Check the tire pressure.
Check the levels of the hydraulic fluid,
engine oil, and coolant.
Use
Figure 3
3. Hairpin cotter
Advertisement
Table of Contents
