Adjusting The Mow-Speed Limiter - Toro 31200 Operator's Manual

1. Traction pedal
2. Stop bolt with jam nut
(forward)
4. Adjust the stop bolt all the way inward (away from the
traction pedal).
5. Push the traction pedal with your hand all the way
forward with light pressure until it stops, and hold it
there. Maintain only light pressure on the pedal when
pushing it to the full forward position.
6. With the seat in the raised position, verify that you are
not overloading the linkage by making sure that the
transmission does not move when you press the pedal
to the stop.
7. Adjust the stop bolt outward (toward the traction
pedal) until there is a gap of 1.5 mm (0.060 inch)
between the head of the stop bolt and the bottom of
the traction pedal.
8. Tighten the jam nut to secure the stop bolt in place.
9. Adjust the reverse stop bolt if the maximum reverse
speed is not acceptable.
Note: For a faster reverse speed, adjust the stop bolt
inward. For a slower reverse speed, adjust the stop bolt
outward.
Adjusting the Mow-Speed
Limiter
Flip the mow-speed limiter
traction speed of the machine.
1. Disengage the PTO, release the traction pedal to the
N position, and set the parking brake.
EUTRAL
2. Move the throttle lever to the Slow position, shut off
the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the jam nut on the stop bolt of the mow-speed
limiter (Figure 41).
Figure 40
3. 1.5 mm (0.060 inch)
4. Stop bolt with jam nut
(reverse)
(Figure 41) forward to limit the
1. Mow-speed limiter
4. Thread the stop bolt in to increase the mow speed and
out to decrease the mow speed.
5. Tighten the jam nut to lock the adjustment.
6. Rotate the mow-speed limiter down, operate the
machine to verify the adjustment, and adjust the stop
bolt again if required.
41
Figure 41
2. Stop bolt w/ jam nut