Fuel Gauge; Ignition Switch - Toro 31200 Operator's Manual

parking brake, press the brake pedal until the parking-brake
latch retracts.
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot pedal
down and pull the steering tower toward you to the most
comfortable position and then release the pedal
Engine-Speed Switch
The engine-speed switch (Figure
the engine speed. By momentarily tapping the switch, you
can increase or decrease the engine speed in increments of
100 rpm. Press and hold the switch to set the engine speed
directly to high or low idle, depending on which end of the
switch you press.
1 2 3
7 6
1. InfoCenter
2. Power take-off (PTO)
Switch
3. Engine-speed switch
4. Steering selector switch
InfoCenter
The InfoCenter LCD display shows the operating status,
various diagnostics, and other information about the machine
(Figure 5).

Ignition Switch

The ignition switch has 3 positions: Off, On/Preheat, and
Start (Figure 5).
Power Take-Off (PTO) Switch
The power take-off (PTO) switch starts and stops the mower
blades (Figure 5).
Steering Selector Switch
Press the steering selector switch to the rear to engage 4-wheel
steering and forward to return to 2-wheel steering
(Figure
5) has 2 modes to change
4
5
Figure 5
5. Power point
6. Ignition switch
7. Deck lift switch
(Figure
Power Point
The power point is a 12-volt power supply for electronic
devices (Figure
Important: If the mower deck shuts down and the
InfoCenter temperature-warning icon is on, push the
PTO knob down, drive to a safe flat area, move the
4).
throttle lever to the S
pedal to move to the N
parking brake. Allow the engine to idle for several
minutes while it cools to a safe level. Shut off the engine
and check the cooling system; refer to
Cooling System (page

Fuel Gauge

The fuel gauge
in the fuel tank.
G026098
1. Fuel gauge
5).
11
5).
position, allow the traction
LOW
position, and set the
EUTRAL
37).
(Figure 6) indicates the fuel level remaining
Figure 6
2. Fuel-tank cap
Checking the